APS and Laser Nozzles
Please use this complete nozzle chart to help identify nozzles that you need to fit your handler or laser.
Contact Adaptsys for a quotation for your nozzles.
Related Articles
BP- 3000 Series Autohandler Maintenance
Weekly – 10 minutes Dust off programmer sites and socket modules with clean, dry compressed air. Inspect Z-rod bellows for proper movement (compression and extension). Check nozzle runout. Replace bellows if run-out is greater than 8 mils. Remove ...BP- 4000 Series Autohandler Maintenance
Weekly – 10 minutes Inspect nozzle O-rings and replace, as necessary. Inspect Z-rod bellows for proper movement (compression and extension). Check nozzle runout. Check air and vacuum gauges. Remove debris and devices from work area. Dust off ...Losing Devices on 3X Laser
Are you experiencing problems, where programmed devices are being dropped inside the laser marker on a 3X system or BPWin, is reporting that no device was found on one of the laser nozzle positions? If so, here are some suggestions to check and ...Why are devices being placed at an angle when using an Automated Programming System(APS)?
Summary Procedure to evaluate and troubleshoot why devices are placed at an angle. Details The angular placement can be any angle, 5 degree , 30 degree, 45 degree, 90 degree, etc. This angular placement can be seen in the sockets, tray, laser nozzles ...BPM Automated Pick and Place Issues
Indicators Pick errors, place errors or vision centering problems occur frequently during a job session. Troubleshoot Ensure that the stations and the package are taught correctly. This is the cause of the majority of Pick-and-Place problems. Run ...