3X Shuttle Auto Retracts After Ejecting Tray
When a tray of devices has been programmed, the tray shuttle will automatically eject the tray.
In the event of hardware failure, the ejected tray can be taken straight back inside the autohandler.
The shuttle needs an adjustment for one of the proximity sensors.
We recommend that you contact your local Adaptsys Support Engineer to arrange a service visit to investigate this.
Related Articles
TS1500 Wing Finger Height Adjustment
A Setup and Calibration Tool (FTRAY-CALTOOL) may be used to check the height of the Wing Fingers. Place the tool on the Top Plate as shown in the image. Make sure that the tool is not sitting on the belt. The top surface of the thin portion of the ...
TS1500 - Tray Stacker Air Pressure Error
Issue BPWin software displays a message to indicate that there is no air pressure to the tray stacker. A physical check of the air input regulators, air lines and connections shows that there is good air pressure going to Tray stacker. The error ...
X Axis Timeout Error on 4000 Series Windows Autohandler
The X-axis is the long, left/right axis. Also called the upper axis. (Note: For old DOS systems, this would be the "Y" axis) The time-out error message is received because the X motor drive system did not get to the encoder position within a certain ...
X Axis Timeout Error on 4000 Series Windows Autohandler
The X-axis is the long, left/right axis. Also called the upper axis. (Note: For old DOS systems, this would be the "Y" axis) The time-out error message is received because the X motor drive system did not get to the encoder position within a certain ...
BPM Automated Pick and Place Issues
Indicators Pick errors, place errors or vision centering problems occur frequently during a job session. Troubleshoot Ensure that the stations and the package are taught correctly. This is the cause of the majority of Pick-and-Place problems. Run ...