TS1500 Wing Finger Height Adjustment

TS1500 Wing Finger Height Adjustment


A Setup and Calibration Tool (FTRAY-CALTOOL) may be used to check the height of the Wing Fingers.
Place the tool on the Top Plate as shown in the image.
ts1500 wing finger height adjustment
Make sure that the tool is not sitting on the belt.
The top surface of the thin portion of the Wing Fingers should be at the same level as the bottom surface of the fingers on the Setup and Calibration tool.
If there is more than .010” between these two surfaces, make the necessary adjustments by loosening the fasteners that attach the Wings to the rotating rod.
Do not adjust the bearing blocks.
The respective Side Cover will need to be removed for this, by undoing the 4 straight slot screws on the top edge of the Tray Stacker.
If you do not have the Calibration Tool, the distance from the Top Plate (not the belt or belt groove) to the top surface of the thin portion of the Wing Fingers should be 0.913” (23.2 mm).
FTRAY-CALTOOL can be purchased directly from Adaptsys.

    • Related Articles

    • TS1500 - Tray Stacker Air Pressure Error

      Issue BPWin software displays a message to indicate that there is no air pressure to the tray stacker. A physical check of the air input regulators, air lines and connections shows that there is good air pressure going to Tray stacker. The error ...

    • 3X Shuttle Auto Retracts After Ejecting Tray

      When a tray of devices has been programmed, the tray shuttle will automatically eject the tray. In the event of hardware failure, the ejected tray can be taken straight back inside the autohandler. The shuttle needs an adjustment for one of the ...

    • TS1500 Not Controlled by BPWin

      Scenario You have a TS1500 installed on your handler but when you run a job, the tray stacker does not operate and no trays are cycled. Solution Check that the TS1500 is powered up and that there are no errors displayed on the error led indicators on ...

    • TS1500 Ethernet Adapter, removal and installation of the correct driver

      Summary Instructions for replacing the TS1500 Ethernet Adapter (p/n: CUSBNIC-2) are listed below. Details Unplug the stacker USB cable at the stacker. Power the entire Automated Programming System down and remove the stackers' left side upper and ...

    • TS1500 - USB Communication Problem

      If you are experiencing issues with obtaining communication via USB to your TS1500 tray Stacker, then please read the following information. You need to ensure that the driver is correct and that you have only one instance of DUB-E100 listed in ...