X800 Valid Site Configurations
On 8th Generation programming sites, upto 4 sockets cards can be place per programming site.
With automated handlers, we employ stepper motors to pull down pressure plates to open and close the sockets and each device algo had code to establish to correct number of the steps that the motor must move to complete this function.
Although 1, 2, 3 or 4 sockets cards can be installed, the quantity and position has an affect on the correct opening and closing of the sockets, more importantly, incorrect setup can cause damage to the motors and/or socket cards themselves.
Related Articles
X300 Site Cooling
The fans are activated by thermistors connected from the analog board heat sink to J9 and J10 on the power board. They will only come on if the site gets above a certain temp the exact temp has not yet been confirmed but about 140 ambient degrees F, ...BPM Microsystems Programming Site and T-post Compatibility
There are a variety of different programming sites available on BPM Microsystems handlers, each have different stepper motors, T-posts and power supplies. This guide serves as a way to help identify the site technology that you have and the ...X Axis Timeout Error on 4000 Series Windows Autohandler
The X-axis is the long, left/right axis. Also called the upper axis. (Note: For old DOS systems, this would be the "Y" axis) The time-out error message is received because the X motor drive system did not get to the encoder position within a certain ...X Axis Timeout Error on 4000 Series Windows Autohandler
The X-axis is the long, left/right axis. Also called the upper axis. (Note: For old DOS systems, this would be the "Y" axis) The time-out error message is received because the X motor drive system did not get to the encoder position within a certain ...Reducing upload and broadcast times for ultra large data files on USB site Autohandlers.
Having received complaints about the lengthy upload time and broadcast time for large data files, BPM have discovered that the ports that the site USB cables are connected to can makes a big difference in process speed. Refer to the attachment for ...